Kratos

NerdQAxe++ Rev7 · Original firmware

Return to stock firmware

Upstream v1.1.1 factory recovery image, mirrored unchanged from the NerdQAxe project.

Factory recovery resets your settings

This is not a settings-preserving update. It replaces the bootloader, partition table, firmware and dashboard, and clears stored Wi-Fi, pool, payout, tuning and other settings. It is not your personal recovery backup.

For a physically confirmed NerdQAxe++ Rev7 with an ESP32-S3 and 16 MiB flash. Do not use this download for a Hammer, Nexus, Bitaxe or another model. This page does not authorize another board revision.

Interrupted Kratos installation? Keep the original tab and normal power connected. If that tab has a saved recovery copy, use its Restore saved firmware path first. If restoration fails, save the diagnostics JSON and get recovery assistance before resetting, closing that tab or switching flashers.

15,802,368 bytes · unmodified upstream file · Inspection and provenance

Verify the download

SHA-256
769d5f959164e20da5aa5ea256e0562f883d6abdd9235d3e06edefab68b25546

The file matches GitHub's published asset digest. Bootloader/application checksums and ESP image digests passed inspection. This does not establish recovery on your physical miner; no hardware recovery test is claimed.

Write the factory image over USB

Use this separate procedure only when you intentionally want a factory reset and have finished or resolved any existing recovery session. Keep any private backup and record the settings you will need to re-enter.

  1. Confirm the board's printed model/revision. Keep its correct normal power supply connected. Use a USB data cable, preferably directly into the computer.
  2. Open the Espressif ESP Tool in desktop Chrome or Edge. Other serial tools must release the port. Start with 115200 baud for a conservative transfer; native USB may not use the selected UART rate.
  3. Click Connect and select only this miner. If needed, follow its documented BOOT/RESET procedure. Stop if the chip, flash capacity or security state does not match; do not disable security or force a rejected write.
  4. Choose the downloaded esp-miner-factory-NerdQAxe++-v1.1.1.bin as one complete file. Set its flash address to 0x0, not 0x10000. This file already contains the bootloader and partition table.
  5. Start programming only after checking the file and address. Keep power and USB connected until writing and verification complete. Do not select an erase-all operation just to resolve a transfer error. If any write/verification error occurs, do not treat the recovery as complete; get assistance.
  6. After successful programming and verification, use the tool's reset/disconnect procedure. Set up Wi-Fi again and enter your own pool and payout address. Check fans, temperatures, power/tuning and new accepted shares before leaving the miner running.

This is a download plus an external flashing tool, not a one-click Original option in the Kratos installer. Do not upload this raw factory file to the miner's OTA page or the Kratos signed-package picker.

Installing Kratos afterward

Stock v1.1.1 is not currently an approved migration to Kratos Rev7 0.6.2. Its bootloader also differs from that release's approved hash. This download restores stock firmware; it does not bypass or fix the existing Kratos compatibility rejection.

Keep the diagnostics JSON for a compatibility review. Do not switch board revisions, force an older image or edit the installer checks to make it pass.

Source and licences

This is upstream NerdQAxe firmware, not a modified or Kratos-signed release. Corresponding upstream source, build instructions and dependency source locations are linked here beside the binary.