KRATOS REV6 BIG SCREEN 0.6.8 — PERFORMANCE / DIAGNOSTIC TEST

Exact target: VastBTC yyslupingB++, Rev6 legacy regulator, ESP32-S3,
32 MiB flash and 480x320 panel, four BM1370 chips. Not ordinary Rev6/Rev7,
320x170 variants, Hammer, Nexus or unknown hardware.

Simplest installation:
https://kratos.mineshop.eu/flash/big-screen.html
Desktop Chrome/Edge; correct normal PSU plus USB data cable. Only the operator
connects and installs. Confirm the actual board, choose an optional private
recovery copy, then explicitly accept factory reset and install.
The page verifies signed firmware, chip/security/flash/layout before writing and
reads back all 32 MiB before enabling the separate Restart button. Keep its tab
visible and computer awake. A recovery copy adds a separate full-flash read.

The combined BIN is written at 0x0 and resets ALL settings, including Wi-Fi,
pool/wallet, tuning, authenticator and custom screens. It is not an OTA file.
Do not mix its application and dashboard with other versions. Do not use the
standard Rev6/Rev7 installer or upload it to an unsigned OTA endpoint.
Configure Wi-Fi and your own pool/wallet using the miner's setup AP after restart.
No customer credentials or payout identity are embedded in the image.

WHAT CHANGED
- LCD uses elapsed wall time, immediate page changes and a real scheduler sleep.
- Dashboard keeps its header, uses a 17 KB original-art thumbnail, removes the
  expensive header blur and uses an opacity-only crest animation.
- System -> Mining diagnostics shows boot-detected chip count, per-chip hardware
  counter rates/freshness, checked/below-job-difficulty/duplicate/old-job nonce
  counts, and mining-job timing. No raw job contents, wallets or passwords.
- Browser USB reads are data-driven instead of short-timer polling; transfer
  progress includes measured throughput and an estimated remaining time.
  Full write/readback checks have not been removed or reduced.

TUNING AND LIMITATIONS
Fresh 750 MHz / 1150 mV, startup minimum 1200 mV. The 800 MHz ceiling,
nominal 100 W Rev6 profile and thermal protection are unchanged. No automatic
voltage or power-limit increase. Programmed MHz is not hardware PLL readback.

An owner-flashed 0.6.7 unit booted/mined but measured about 3.7 TH/s at this preset.
0.6.8 adds diagnostics to investigate that shortfall; it is NOT a validated 6 TH/s
fix. Software builds/tests do not establish real screen speed, chip stability,
thermal performance or recovery. Have the operator check one unit and share the
System diagnostics, accepted shares and temperatures before repeating on a batch.

Recovery: retain a private copy or the manufacturer's exact matching recovery
image/procedure. Never distribute a configured miner's flash dump. Interrupted
browser writes require same-unit download-mode reconnect and explicit repair;
do not restart an incompletely verified installation.

Source, licences, checksums and earlier immutable downloads:
https://kratos.mineshop.eu/firmware/rev6-big-screen.html#manufacturer
